General purpose neutral silicone sealant red,blue ,gray,green other color
Gorystar N33 is a one-component neutral cures silicone sealant. It design for general-purpose with exceptional adhesion to a very wide range of building materials including PVC, polycarbonates, aluminium, lacquered aluminium, etc.
Production introduction:
Deoximation type, one-component, neutral cure, easy to use.
Excellent mechanical strength.
Excellent resistance for the UV and aging, and there is no bad effect with the sunshine, rain, snow and extreme temperature.
Good compatibility with all neutral silicone sealant and silicone rubber.
Outstanding adhesion to most building materials.
Application:
Main used to caulk seal of glass and aluminum curtain wall weathering.
Application to the installation and weathering caulk seal for all types of doors and windows.
Used for caulk seal. Metal bonding and metal structural engineering.
Caulking seal for a variety of metal aluminum curtain wall.
Weathering caulk to seal a variety of glass curtain wall...
Technical Data:
| Performance |
Index |
| Sagging Degree(mm) |
≤1mm |
| Extrusion Performance(s) |
≥ 80ml/min |
| Surface Drying Time(min) |
≤ 60min |
| Stretching Binding Strength(Mpa) |
≥0.6Mpa |
| Maximum Strength Elongation(%) |
≥150% |
| Displacement Capacity(%) |
± 25% |
| Hardness HsA |
30-50 |
How to use:
Using a solvent or other means to clean the surface of the material to be bonded.
Pasting low viscosity tape on the parts needed protect.
Triming and removing the tape before the glue has not been vulcanized.
Restriction:
Restrictions:
Do not used as a structural adhesion.
Do not construction on the wet surface.
Do not used on the surface of the oil of oil leakage.
Do not apply to the application of structural assembly or for injections of the substrate surface temperature engineering applications of more than 50º C.
Long buried interface should not be used.
Directions for use:
Ensure all the surfaces to be sealed are clean, dry and grease-free.
Cut off the tip of the small threaded protrusion on top of the tube. Screw the pointed nozzle to the remianing.
Apply sealant with caulking gun. Tje sealant will form a layer on the surface in approximately 10 minutes at 25 degree and will be dry to touch in 1 hour. It will be fully cured in 24-48 hours depending on the surface to be sealed.
Warning:
Ensure good ventilation when used indoors. Avoid direct contact with skin. If exposed to eyes, flush with water and consult with a physician immediately. Keep out of reach of children.
Do not use for structural glazing applications.
Storage:
Packing: 300ml
Colour: Clear White Black Bronze Grey
Storage: Temperature should not exceed 30 degree for prolonged periods.
Caution: Use within 12 months.
Audited Supplier 
){kind=link}